Categories: Hardware

FONTE: Ultimate64

Complete set:

  • Ultimate-II+ Cartridge (Black)
  • Short IEC cable (30 cm)
  • Tape Adapter Set (for .TAP files)

Ultimate II+ Features:

  • Full, cycle accurate emulation of two real Commodore 1541 diskdrives.
    • Uses .D64 and .G64 files stored on USB stick
    • Supports .G64 files as well (Read/Write)
    • Configurable IDs
    • Configurable ROM (1541/1541C/1541II or custom)
    • RAMBOard memory expansion (up to 40K)
  • Built-in Speaker; outputs drive and floppy sounds
  • Support for USB storage devices (stick, card reader, and even HD)
  • 100 Mbps Ethernet port (for use with Telnet or FTP)
  • FAT/FAT32 support, with sub-directories and long filenames
  • ISO9660 support with Joliet, for reading .ISO files and access external CD/DVD drives through USB
  • Battery backed up Real Time Clock
  • Command Interface module with UltimateDOS
    • Accessible module through I/O space that allows direct commands to Ultimate-II
    • Ultimate-DOS, I/O space driven direct file access to SD/USB
  • Dual SID implementation, optionally 8 voices each
  • Ultimate Audio module
    • Up to 7 voices of sampled audio simultaneously
    • Accessible through I/O space
    • 8- or 16bit samples
    • up to 48 kHz sample rate
  • Built-in SID player; plays SID files on either ‘real’ SID or emulated SID.
  • C64 cartridge emulation:
    • Final Cartridge III
    • Action Replay
    • Retro Replay
    • Super Snapshot
    • Turbo Assembler w/ Codenet
    • Epyx Fastloader
    • Custom 8K/16K carts
    • Custom Ocean / System3 carts (up to 512K)
  • Commodore 1750/1764 REU
    • REU Compatible
    • Size selectable from 128K up to 16 MB
    • Can be combined with Retro Replay and SuperSnapshot compatible roms
  • Flexible freezer menu
    • select, mount, create D64 images, browse disk images
    • create new directories, delete files
    • Ultra fast DMA load of single file programs (.PRG files on USB, inside .D64 or .T64)
  • Configuration screen, with resident settings
  • Tape emulation, through special USB3.0 cable to tape port of C64*
    • Load .TAP files to C64
    • Capture tape data from C64 to .TAP file
    • Capture tape data from a datasette and store it as .TAP file
    • Write .TAP files back to tape, using a Commodore tape deck
  • Totally rewritten firmware, for easier expansion and maintenance

* Tape emulator cable is an accessory, which is needed to work with tap files.

Hardware Specifications:

  • Board size: 62 x 90 mm
  • Sturdy ABS plastic case
  • 1M-gate FPGA
  • Full size 6-pin DIN connector (IEC)
  • 5 MB Flash ROM
  • 64 MB DDR2 SDRAM
  • Three USB host ports
  • One 100 Mbps Ethernet port
  • Stereo audio output
  • Stereo audio input (currently not yet used)
  • Specialty USB 3.0 port with USB 2.0 signals for storage device OR cable to tape adapter board (for C2N emulation), or other future features.

    Lascia un commento

    Il tuo indirizzo email non sarà pubblicato. I campi obbligatori sono contrassegnati *